How To Save Wet Cell

Get it out of the water as soon as possible. The plastic covers on cell phones are fairly tight, but water can enter the phone over time. But this time may be quite short - 20 seconds or less. So grab your phone quickly!

Remove the battery. This is one of the most important steps. Don't take time to think about it; electricity and water do not mix. Cutting power to your phone is a crucial first step in saving it. Many circuits inside the phone will survive immersion in water provided they are not attached to a power source when wet.

Remove your SIM card. Some or all of your valuable contacts (along with other data) could be stored on your SIM. To some people this could be more worth saving than the phone itself. SIM cards survive water damage well, but some of the following steps are unnecessary i.e. don't heat it. Just pat it dry and leave it aside until you need to connect your phone to your cellular network. Note that many phones by specific providers, such as Verizon, do not use SIM cards.

Dry your phone. Obviously you need to remove as much of the water as soon as possible, so you can to prevent it from getting into the phone. Use a towel or paper towel to remove as much of the water as possible.

Allow the phone to dry. Since you do not want to ruin your phone or lose all of the numbers in your phone book, you need to allow the phone to dry. Also, ringtones and graphics stay with the phone - not the SIM. Don't try putting the battery back on to see if it works as this would risk damaging the phone with a short circuit. Leaving your phone in a bowl of dry rice will help to expedite moisture evaporation.

Heat your phone. Apply enough heat to your phone to cause the water to evaporate without water-logging your digital screen. One of the best things you can do to save a cell phone is to set it on the back of your computer monitor or TV screen over the heat vents. This is usually the perfect amount of heat to fix your phone. The convection action of the heat vents will help carry away the moisture in your phone. Leave the phone on the heat for at least 2-3 days.

Test your phone. After you have waited 3 days, make sure everything is clean and dry looking and re-attach the battery to the phone and see if it works. If your phone does not work repeat step 4. If it still won't work, try taking your cell phone to an authorized dealer. Sometimes they can fix it.